nkottler

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Deck and lines plan #34397
    nkottler
    Participant

    Thanks cruzmayora I’ll look at it.
    Is your language Spanish?
    Nick

    in reply to: Deck and lines plan #34396
    nkottler
    Participant

    Hello Mike
    I made the deck by extruding the hull top sideways 20mm (hull thickness)in then 250mm down to create the gunwale then sideways to the centreline.
    Take two examples: If I had a cylinder and wanted to create a cylinder wall thickness using this teqnique the sideways extrusion would not work as the wall would go from full on one quarter to nothing on the next.
    As the second example, when I extruded the edge down, some of the points had gone through the hull surface and all of them had to be manually placed to get the correct hull thickness. My question was whether it is possible to do this type of extrusion to follow another surface.
    Sorry this is quite a long explanation..
    Nick.

    in reply to: Deck and lines plan #34391
    nkottler
    Participant

    Thanks Mike
    I have managed to draw in the deck. Is there a way to extrude parallel to a surface?
    Nick.

    in reply to: Deck and lines plan #34386
    nkottler
    Participant

    I have the waterlines now thankyou. The check box was part of the problem,another was that I was entering the intervals in meter not mm.
    Still stuck with the deck.

    in reply to: Deck and lines plan #34385
    nkottler
    Participant

    Thanks Karma
    I have designed a hull and now I want to create a deck below the top edge of the hull but I do not understand how to do it since I can only have two faces from any edge. is that clearer?
    I will experiment with the check-box, thanks for the suggestion.

Viewing 5 posts - 1 through 5 (of 5 total)