Grand

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • in reply to: building a boat using delftship tool #38479
    Grand
    Participant

    tx jayoh!
    this is also my impression that ther would be some inacuracies. Does your printout show properly the numbers because on the Unfold screen some numbers overlap. the printout is only available in the PRO version but I wont buy it if the printou has the same errors than the screen output.
    I designed a very simple little boat and when I unfold it it gives me a small piece of plate (to close the hull) that apparently is missing on the model but zooming in I cannot find where it is missing…
    On the other hand I think there will always be inacuracies that we have to correct during the building process.
    I am wondering if people use directly the Unfold printout or save as dxf and then open it in another program to finetune the design??
    Nice boat yours…

Viewing 1 post (of 1 total)