way to calculate/input angles

This topic has 0 replies, 1 voice, and was last updated 11 years, 10 months ago by Jamie.

Viewing 0 reply threads

Author

Posts
- January 29, 2012 at 20:56 #35521
  
  Jamie
  Participant
  
  i have been designing an aluminum planing hull. i have a suggestion that when drawing a boat you can select a corner point and two edges going from that point and say i want that at x degrees. or you can draw a boat then select a corner point and two corresponding edges and ‘ask’ the angle. for example on my file i will attach…
  
  the transom has 4 bends in it. i know that two are a 90 degree bend but what are the other two? i think this would greatly increase the functionality of this software. maybe it exists allready and i dont know about it?
Author

Posts

Viewing 0 reply threads

You must be logged in to reply to this topic.