Unwanted curved surface
- This topic has 1 reply, 1 voice, and was last updated 11 years ago by .
Viewing 1 reply thread
Viewing 1 reply thread
- You must be logged in to reply to this topic.
› DELFTship forum › Hull modeling › Unwanted curved surface
I did not want that curved surface!
My wish was to get curved surface only as the outer edges (lower and upper), with mash without triangles. I should do something about that…
Subdivide the surface in squared areas?
Kind regards,
I obtained wanted surface by extruding the edge. Extruded edges should not be crease.
Kind regards,