Unfold as single part problem.

DELFTship forum Hull modeling Unfold as single part problem.

Viewing 1 reply thread
  • Author
    Posts
    • #36188
      Mowaterfowl
      Participant

      I know that some layers such as the bottom of a flat hull or transom often unfold as a single part. In my file, these two parts, and the deck all do this. However, I do have a rear section that is flat and has a flat straight edge on Y=0. However, it unfolds as two parts. Any ideas?

    • #36189
      Marven
      Keymaster

      Perhaps you can postsome images of the surface in 3D and the unfolded surface?

Viewing 1 reply thread
  • You must be logged in to reply to this topic.