Trimming unnecessary part of the surface
- This topic has 2 replies, 2 voices, and was last updated 9 years, 6 months ago by .
Viewing 2 reply threads
Viewing 2 reply threads
- You must be logged in to reply to this topic.
› DELFTship forum › Hull modeling › Trimming unnecessary part of the surface
Can I trim the part of the bulkhead surface running out of the hull body? I want to avoid manually adjusting of the bulkhead edge.
Kind regards,
I am using DELFTship Free.
Kind regards,
If you modelled the bulkhead in adiferent layer than the hull, you can use the “Find the intersection of two layers” command, make sure to indicate that the new points have to appear in the bulkhead.
Good Luck