Table of offsets for model with chines
- This topic has 1 reply, 2 voices, and was last updated 12 years ago by .
Viewing 1 reply thread
Viewing 1 reply thread
- You must be logged in to reply to this topic.
› DELFTship forum › Hull modeling › Table of offsets for model with chines
I have exported the table of offsets but i would like a table of offsets that gives only the point where the chine is. I have designed a model that i plan to construct with plywood. The model has a flat plywood bottom and one chine. Is there a way to expot a table of offsets that outputs deckline, chine, and bottom off of the baseline?