Send to back bring to front

[Hrvoje]

Does it exist possibility to send a layer back or bring it to front? To avoid covering the subject which is closer to the eye with one which is behind it.

Kind regards, Hrvoje

[otaku]

If level of interest matters, i, too, would like to express a long-time desire for this capability/functionality/feature.

[Hrvoje]

I was looking in the user manual to find this possibility, but couldn’t find. So good software should have it somewhere. 🙂

Kind regards, Hrvoje

[otaku]

It seems to me that if this becomes an available feature, then clicking on the edge should automatically highlight the directly-connected end points or other controls that were not used in the creation of the selected edge. This would resolve my issue with having to turn off layers having points that are in the way.

Similarly, clicking on a point would highlight the lines directly connected so it becomes easier in either case to manipulate only the desired items. This is more than nice-to-have when the drawing has coincident points that locate items independently of something else there.

[MICHAEL KERR]

Any part of your vessel can be turned into different layers, and these layers can be turned off and on by making them invisable, look in Layer Properties. Or you can turn off the starboard side (Show both sides of Model icon) of your vessel and rotate it in the Perspective view to highlight and manipulate control points etc in that view or others.

[Author]

Posts