Schippersvlet
› DELFTship forum › Hull modeling › Schippersvlet
- This topic has 5 replies, 3 voices, and was last updated 13 years, 4 months ago by
Pieter Klein.
-
AuthorPosts
-
-
November 1, 2009 at 22:37 #33728
Pieter Klein
ParticipantI’ve been trying to draw the hull of a Dutch ‘Schippersvlet’.
I’m almost satisfied, except for the crease in the middle of the front part of the boat, but if you like to have the design, you may.
(English is NOT my native language) [file name=vlet.fbm size=108382]http://www.delftship.net/delftship/media/kunena/attachments/legacy/files/vlet.fbm[/file]Attachments: -
November 2, 2009 at 02:31 #33729
MICHAEL KERR
ParticipantHi,
I haven’t see your file yet but you could change the precision of your model to Highest first and see what effect that has.
Mike -
November 2, 2009 at 11:46 #33732
Marven
KeymasterYou can remove the crease as follows:
1. Make sure the control net is visible.
2. Set your view to top view
3. Make sure the two front most points of each row of controlpoints have the same X and Z coordinate.Attachments: -
November 2, 2009 at 13:22 #33733
Pieter Klein
ParticipantI haven’t see your file yet but you could change the precision of your model to Highest first and see what effect that has.
You mean “subdivide controlnet”. That doesn’t make much difference.
Make sure the two front most points of each row of controlpoints have the same X and Z coordinate.
That’s it (almost)! I think I have to add a few more controlpoints.
Thanks!btw.
The design is based on a 70 years old ‘schippersvlet’. -
November 2, 2009 at 14:10 #33734
Marven
KeymasterI’m familiar with that type of boat.
Very sturdy and characteristic! -
November 10, 2009 at 21:17 #33740
Pieter Klein
ParticipantI still can’t find the right way to do it. It’s very hard to get the right shape when you add extra edges and controlpoints….
-
-
AuthorPosts
- You must be logged in to reply to this topic.
Your account
Recent Topics
-
Modeling the 1907 U.S. Brigantine Galilee
by
Terrance Egolf
1 month ago -
install problems
by
tcurdt
1 month ago -
VCG and GM of Smit Rotterdam
by
DuncanH
1 month ago -
Revision/save history?
by
Jamie
1 month, 1 week ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
3 months, 2 weeks ago -
Cylinder through curved deck
by
RuudN
3 months, 2 weeks ago -
Exporting table of offsets
by
Peter Mitchell
4 months, 2 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
4 months, 2 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
4 months, 3 weeks ago -
Deck Camber
by
patmat41959
4 months, 3 weeks ago