Problems closing the transom

DELFTship forum Hull modeling Problems closing the transom

Viewing 2 reply threads
  • Author
    Posts
    • #36419
      Klaus -Peter Knopik
      Participant

      Hi folks,
      constructing a boot I designed the hull. There after I created the deck. At least I have problems to close the transom. What is to do?

      Delpht-Anfrage01.jpg

      All the best from Kanu-Werft
      Klaus

    • #36427
      Icare
      Participant

      Well, it depends on the way you did it and what the problem is! :S

      When I began using Delftship, my problem was to knit the edges of two adjacent planks/surfaces. My models were looking perfect, but their the planks’ edges weren’t knited, they were just overlapping. Is this your problem?

      To know it, select each point along the transom perimeter and change its coordinates. Is the other planks’ edge (sideboard, bottom or deck) distorted (like rubber) or does it remain unchanged (and a gap appears between the transom and the other plank)?

    • #36428
      Klaus -Peter Knopik
      Participant

      The shapes of the hull are all right. But when trying to close the transom I run crasy because I always lost the last “frame” by closing with the close tool.
      Now I did it consequently till the whole transom was closed. After that I set the corners and some points to knuckle and it was finished. The after shape was refound.
      Thanks for respond.

      All the best from Kanu-Werft
      Klaus

Viewing 2 reply threads
  • You must be logged in to reply to this topic.