Need Help..,

Viewing 2 reply threads
  • Author
    Posts
    • #36437
      pothiraj
      Participant

      Dear all, I have created a model using Delftship. When, I take, Design Hydrostatics it shows only zero’s in properties. I have attached a model and Design Hydrostatics report also..

      Can anyone clarify me, why it is hapeening like this??

      DesignHydro.pdf

      Thanks in advance..,

    • #36438
      Marven
      Keymaster

      You have a leak point, causing the hydrostatics to fail.
      Press “Check model” on the Tools tab to get an overview of all leak points. Only the ones below the water plane are relevant in the upright condition. In your particular case there is a point 2cm of the center line. If you set the y-coordinate to zero it should be fixed.

    • #36439
      pothiraj
      Participant

      Thank you sir..

Viewing 2 reply threads
  • You must be logged in to reply to this topic.