Solved – I can not to “un-Corner” the point

DELFTship forum General Questions Solved – I can not to “un-Corner” the point

Viewing 1 reply thread
  • Author
    Posts
    • #44448
      Hrvoje
      Participant

      I have the following case: The point is on the bottom of the hull. The point is one of 11 points defining the hull’s contour. In some “mysterious” way one point becomes a corner point.

      • I select the point,
      • I uncheck the “corner” box in a small window,
      • The check box is empty, so the point is not corner point,
      • I deselect the point,
      • the point behaves like a corner point again,
      • I select the point again and yes, it is the corner point box again!

      How to get rid of the “corner” mark?

      Thank you for any help!

      P.S. I use DelftSHIP Free 6.27.259

      P.S. This point was used in two layers.

      Kind regards, Hrvoje

      • This topic was modified 3 months, 3 weeks ago by Hrvoje.
      • This topic was modified 3 months, 3 weeks ago by Hrvoje.
    • #44465
      Maarten
      Keymaster

      Without a screen shot is is really hard to tell what may be going on. Most likely your point is at the intersection of more than 2 crease-edges- this will always make a point a corner point

Viewing 1 reply thread
  • You must be logged in to reply to this topic.