Hull corner frames?

› DELFTship forum › Hull modeling › Hull corner frames?

Viewing 0 reply threads
  • Author
    Posts
    • March 14, 2011 at 18:49 #34734
      Martin Kristiansen
      Participant

      Good day,

      Is it possible to get Delftship to produce/draw the outline of a hull “corner” frame, say e.g. at a 45 degree angle to the centerline? Have attached a picture showing the type of frame I would like to have an outline of.

      If not, do you have any other suggestion as how to produce an outline of such a frame?

      Best regards

      Martin

      Frames.JPG

  • Author
    Posts
Viewing 0 reply threads
  • You must be logged in to reply to this topic.