How Do I Change Global Scale of Control Points?
› DELFTship forum › Hull modeling › How Do I Change Global Scale of Control Points?
- This topic has 3 replies, 2 voices, and was last updated 12 years, 3 months ago by
Hrvoje.
-
AuthorPosts
-
-
January 27, 2010 at 08:21 #33942
S . Warr
ParticipantI am using DelftShip Free.
My problem is that my project (an IOM R/C sailboat @ LOA = 1 meter) was set to actual scale, resulting in points reading in four (4) decimal points.
I would like to “scale up” the project (say to LOA = 100 meters) to permit greater accuracy in design, but when I change the Project Settings the points are still identified as the decimal coordinates of original Project Settings.
How do I “scale up” (from LOA = 1 meter, to LOA = 100 meter) with concurrent change in coordinates (0.00 reflected as 1.00)?
The follow-on to this question, is how to set back to original settings (LOA = 1 meter) to facilitate use of Hydrostatic readings?
I’ve wracked my brain on this, and acknowledge that I am probably not “seeing the forest for the trees… Any help that can be offered will be greatly appreciated!
-
January 27, 2010 at 14:00 #33947
Hrvoje
ParticipantHi!
Try “Transform->Scale” from the top toolbar to see if this will fulfill your needs.Kind regards, Hrvoje
-
January 27, 2010 at 17:39 #33949
S . Warr
ParticipantDida,
If you are ever standing close to me at the bar, you will never have to pay for your drinks!
Somehow, I knew that the answer was too close for me to see.
This fixes it – EXACTLY!
Thank you for taking the time to post your respons.
S/F, Phillip
-
January 27, 2010 at 18:23 #33950
Hrvoje
ParticipantOK! I prefer cappuccino! 🙂
Kind regards, Hrvoje
-
-
AuthorPosts
- You must be logged in to reply to this topic.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 2 weeks ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago