Getting creased edge to show on developed plates

DELFTship forum Hull modeling Getting creased edge to show on developed plates

Viewing 3 reply threads
  • Author
    Posts
    • #44952
      DW
      Participant

      After creating a chine model from a table of offsets import, I have added a new creased edge between the sheer and chine 1. However, the new face (layer?) defined by the area between the sheer and the new creased edge does not appear on the developed plates tool (the original plates before insert are shown). Anything I should be doing to force consideration of the edge insert to show on the plate development tool? Any advice much appreciated. FREEBOAT-CHINE-seaclipper-M60-float-beams-further-aft-v4

      Attachments:
    • #44955
      Marven
      Keymaster

      I cannot open your file.
      Are you sure it is created with DELFTship?

    • #44956
      DW
      Participant

      Good morning Marven. Thanks for taking the time to reply. It was in fact created on Freeship which I had understood to be a cut-down version of Delft and therefore compatible with the Delft software – but maybe not.  I´ve reattached the file on the faint hope it might still work. But if not,  I expect I can find a work around by re-inputting the hull offsets including the extra chine.

      Attachments:
    • #44958
      Marven
      Keymaster

      Hi DW,

      FREE!ship was the predecessor of DELFTship 18 years ago.
      During that time it has been further developed by other programmers and it is no longer supported by us.

Viewing 3 reply threads
  • You must be logged in to reply to this topic.