Export offsets
- This topic has 0 replies, 1 voice, and was last updated 11 years, 2 months ago by .
Viewing 0 reply threads
Viewing 0 reply threads
- You must be logged in to reply to this topic.
› DELFTship forum › Hull modeling › Export offsets
Hi,
I am trying to export offsets on a chined design but only get the following. What am I doing wrong please?
0 // Number of waterlines
14 // Number of stations
1 // Read deckline
1 // Read contour
1 // Read aft contour
1 // Read forward contour
0 // Read flat of bottom
16.977 // Length
1.780 // Beam
0.542 // Draft
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000
0.000 0.000 0.000 0.000