Draft marks in Stability report

[Sergio Diaz-Ibieta]

Dear Martijn,
In the Project Settings/Main Particulars window one can add a lot of draughts, which is quite important to check special locations other than fwd and aft marks, such as sonar domes, protruding structures for acoustic sensors (gondola) in research vessels, propellers going below baseline, etc.
However, in the stability report there are only 2 draught marks and something called Draught BoK, which I presume is related to the mid distance between marks and not to the real midship draught mark.
As we need to know all the drafts declared in the Main Particulars, I would kindly request that you include these draughts in the Stability report, with the names declared by the user if possible.
Thanks a lot and best regards.

[Sergio Diaz-Ibieta]

See attached figure where you can see the forward protruding structure called gondola which is fixed to the hull and accommodates electronic equipment. The four drafts in the model are: Forward mark (not same as FP), gondola, midship mark and aft mark draughts.

[Sergio Diaz-Ibieta]

Hi Martijn,
Have you had the chance to read my thread (Draft Marks topic)?

I understand that the Fwd and Aft Draught Marks in the Stability Report are taken as the foremost and aftmost defined draught marks in the Main Particulars, regardless the Marks titles. Is this correct?
Is it possible that you consider the Stability Report with the Draught marks as they are defined in the Main Particulars (not only the fwd and aft marks, but all)?

Looking forward to hear from you soon.

Best regards,
Sergio

[Author]

Posts