Discontinuity of the side surface
- This topic has 2 replies, 2 voices, and was last updated 11 years, 7 months ago by .
Viewing 2 reply threads
Viewing 2 reply threads
- You must be logged in to reply to this topic.
› DELFTship forum › Hull modeling › Discontinuity of the side surface
Hi!
On the attached picture is possible to see the discontinuity of the hull surface in the deck line area. I added the bulwark in later phase of modeling.
How can I obtain that the continuation line of the frame (bulwark) is tangent on the hull frame line?
(Can’t do that on crease edge?)
Kind regards, Hrvoje
Hi Dida,
you will have to define additional internal edges along lines above and below the deck line and then refine your model manually point by point. This is (as far as I know) the only way to reconstruct the primordial continuous shape of the frame at the deck line.
Regards
Klaus
Thank you Claus. I expected that this will be the only solution. It is still better than 50 years ago without software like this. 🙂
Kind regards, Hrvoje