Developable surface (wrong orientation)

This topic has 1 reply, 2 voices, and was last updated 10 months, 3 weeks ago by Maarten.

Viewing 1 reply thread

Author

Posts
- July 15, 2022 at 16:13 #44635
  
  Hrvoje
  Participant
  
  Hi!
  
  When I tried to see the developable surface of my model, I noticed that two parts have the wrong orientation compared with the others. Is this possible to eliminate?
  
  I attached the picture to illustrate the problem:
  
  Kind regards,
  
  Hrvoje
  
  Kind regards, Hrvoje
  
  Attachments:
  You must be logged in to access attached files.
- July 19, 2022 at 11:46 #44651
  
  Maarten
  Keymaster
  
  Hi Hrvoje,
  
  When DELFTship creates the developed plates it tries to optimize the space used, by rotating and moving each layer.
  
  A result can be that parts are rotated 90 or 180 degrees if that would result in a better fit.
  
  Of course you can manually rotate them back before saving / printing / exporting..
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.