Designing hull form

› DELFTship forum › Hull modeling › Designing hull form

Viewing 0 reply threads
  • Author
    Posts
    • December 10, 2010 at 01:01 #34469
      Hrvoje
      Participant

      I am designing the hull of the traditional ship trabakul (trabaccolo). This is the view on the whole ship:

      And this is the small problem I am faced with:

        I can’t select two edges created by extrusion. These edges are red.
        Also I have the problem with two leak points. They should not be here

      Kind regards,

  • Author
    Posts
Viewing 0 reply threads
  • You must be logged in to reply to this topic.