Control curves
- This topic has 5 replies, 3 voices, and was last updated 7 years, 4 months ago by .
Viewing 5 reply threads
Viewing 5 reply threads
- You must be logged in to reply to this topic.
› DELFTship forum › Hull modeling › Control curves
Hi,
I defined some control curves which control points lay on the same layer (x), but they assume some odd shape.
how can I refine these curves?
Thanks
Hi,
at last I succeded to refine control curves.
Is it possible to tie down only X or Y or Z coordinate of the control points?
Thanks
G
Ok. Thanks.
No need to say your’s a great software! 🙂
Giulio
Thanks B)