blunt bow-keel junction

DELFTship forum Hull modeling blunt bow-keel junction

Viewing 7 reply threads
  • Author
    Posts
    • #33757
      tata85
      Participant

      Hi All!

      I am trying to model a small sailing yacht in Delftship and I have the followong problem:
      I would like to achieve a nice blunt bow-keel junction (something like on a Laser, for example).
      I already have made the bow and the keel round, but for some reason, where thes two are joined, I get a sharp edge on a short piece (see picture).
      Can anyone help me with this?
      Thanks in advance,
      best regards,
      Tamás

      Attachments:
    • #33758
      Marven
      Keymaster

      can you post a picture of the controlnet?

    • #33759
      tata85
      Participant

      Thank you for your quick reply.
      I think it is the best if I send you the fbm file.
      Regards,
      Tamás [file name=PaugerBird_11.fbm size=26384]http://www.delftship.net/delftship/media/kunena/attachments/legacy/files/PaugerBird_11.fbm[/file]

      Attachments:
    • #33765
      tata85
      Participant

      Any ideas?

    • #33767
      Marven
      Keymaster

      Sorry, it still isn’t clear to me.
      Should the junction of the bow and bottom be a knuckle, or a hard point?

    • #33770
      tata85
      Participant

      Sorry, I didn’t put my question properly enough.
      My problem is that although I have designed the waterlines to be blunt at the bow and the stations to be blunt at the keel, I still get a sharp edge on a short section where bow and keel meet.
      How can this be avoided and the junction of bow and keel made to be blunt, too?

      Thanks in advance,
      Tamás

      Attachments:
    • #33772
      Marven
      Keymaster

      Like this you mean?

      I only connected the lower point of the forefoot the the one on the centerline, amd increased the beam of that point a little. [file name=PaugerBird_mod.fbm size=26440]http://www.delftship.net/delftship/media/kunena/attachments/legacy/files/PaugerBird_mod.fbm[/file]

    • #33773
      tata85
      Participant

      Thank you very much, this is just what I wanted to achieve!
      By the way, isn’t an irregular grid such a big problem after all?
      I remember having trouble to import a hull to Rhino once (through iges), and as I found out the problem was caused by the irregular surfaces of the DelftShip model…
      Thanks a lot, best regards:
      Tamás

Viewing 7 reply threads
  • You must be logged in to reply to this topic.