Re:Table of offsets – Import/Export
› DELFTship forum › Hull modeling › Table of offsets – Import/Export › Re:Table of offsets – Import/Export
Since the last post to this thread is over a year ago, I’m not sure anyone is still posting…But if you are.
A couple of questions.
1. I have looked over the docs and sample offsets table description but don’t find how one describes the flat of bottom. All the examples have a 0 for that line – indicating the flat of bottom is not described in the offsets file. So where does the flat of bottom go.
2. I have also seen issues with the offsets table import and export. If I import an offset table (a good one) it comes in just fine. If I then export that offset table, it seems to export ok (that is the correct format but not necessarily the offsets themselves). But if I import that exported offsets, the body, plan, and profile are all messed up.
what gives.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 1 week ago -
Thank you for helping out!
by
Maarten
2 months, 1 week ago