Re:skeg keel and rabbet

Re:skeg keel and rabbet

#33503
MICHAEL KERR
Participant

Chandler,
if you use the rounded bow method just remember if you
design the keel you can do it 2 ways, design the keel up into the hull which will change the hull shape or lower the keel but you will have to put some control points to keep the hulls current shape until the keel is formed then go to Tools–>Move to Baseline so the baseline is at the lowest part of the keel, eg if you
lower the keel it will be in negative numbers so your got to re-set the baseline after your finished the keel. OK