Re:Send to back bring to front
› DELFTship forum › Hull modeling › Send to back bring to front › Re:Send to back bring to front
January 20, 2010 at 04:54
#33897
Participant
It seems to me that if this becomes an available feature, then clicking on the edge should automatically highlight the directly-connected end points or other controls that were not used in the creation of the selected edge. This would resolve my issue with having to turn off layers having points that are in the way.
Similarly, clicking on a point would highlight the lines directly connected so it becomes easier in either case to manipulate only the desired items. This is more than nice-to-have when the drawing has coincident points that locate items independently of something else there.
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago