Re:Platedevelopment does NOT work as expected
› DELFTship forum › Hull modeling › Platedevelopment does NOT work as expected › Re:Platedevelopment does NOT work as expected
May 20, 2010 at 11:18
#34110
Participant
Hi Marven,
in principle it’s getting better, but not completely !
As the attachement shows, after inserting a “row of points” (without inserting an edge) there’s still a small knuckle (stem or stern ?) at the position of
of the inserted point just on one end (red circle). After inserting the edge, the picture is the same as
at the beginning (blue circle). The other important thing is, when I insert a “row of points”, hydrostatics are changing !!
I think that special case isn’t regarded in the development function !
Best Regards
Johannes
Attachments:
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago