Re:Inserting offsets for asymmetrical hull design?
› DELFTship forum › Hull modeling › Inserting offsets for asymmetrical hull design? › Re:Inserting offsets for asymmetrical hull design?
November 9, 2009 at 12:41
#33739
Keymaster
The offsets import routine is indeed for symmetical hulls. However it should be possible to import an asymmetrical hull the following way:
- First import the starboard side of your hull
- Scale it in the Y-direction with scale factor -1.0. This way the hull is mirrored to startboard side
- Save your hull as a part
- Now import the portside offsets. Starboard side will be deleted from your model
- Finally import the part again in the model.
- The final step is to connect both halves, if it has not been done already by the program
Your account
Recent Topics
-
Download Problems
by
William Boebert
1 week ago -
Developable surface (wrong orientation)
by
Hrvoje
1 month ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
1 month ago -
Need OSV, AHTS,PSV Vessel hull bodylines plans
by
jacksparrow1912
1 month, 1 week ago -
Can’t figure out how to model the back
by
Tidexon
1 month, 2 weeks ago -
Critical Program Error
by
Allan Russell
1 month, 2 weeks ago -
Saving reports in Word or Excel format
by
Berislav Tusek
1 month, 4 weeks ago -
Attaching keel to hull
by
Matthieu
2 months ago -
Modeling the 1907 U.S. Brigantine Galilee
by
Terrance Egolf
2 months ago -
HOW TO USE THAT SOFTWARE
by
mirmir
4 months ago