Re:I failed to make flat of bottom in my model
› DELFTship forum › Hull modeling › I failed to make flat of bottom in my model › Re:I failed to make flat of bottom in my model
How are your control points? Is it possible they are too close together, or maybe to tightly adjusted?
(I had (and to some extent still have) that problem. But due to the scale of my hull, and since i’m only doing a concept naval hull, i’m not too worried. I hope to resolve it after i purchased a license of DS Pro. But, fi you’re modeling a very small craft, i can see you’ll be very concerned about the accuracy.)
You might have to bring some of the control points outward a bit. Then, if you have a cad program, check out the DXF 3D Polylines and DXF 3D Mesh there, too.
In DS, turn on the inside control mesh and see what your shell is doing as you edit the nodes. Some you may want to automatically adjust, one axis at a time, keeping care to not make too many test adjustments too quickly.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 2 weeks ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago