Re:how to connect a sent fin keel to the hull.
› DELFTship forum › Hull modeling › how to connect a sent fin keel to the hull. › Re:how to connect a sent fin keel to the hull.
Hi enricofontanesi,
Do you remember that little box after you did Edit…
Point…Intersect Layers its called Intersect Two Layers box. Well you have to put the keel layer up the top and the hull down the bottom, to me it sounds like you did it the other way round, you want the intersection points on the keel not the hull.
Once your corrected that and your keel has a yellow intersection curve around it, make sure the yellow line goes all the way along the keel ( usually in my experience it doesnt join up to all the control points on the intersection line, just check to be sure ) now turn the yellow intersection line to a red crease.
Highlight all the red lines above the intersection line and Edit…Delete OR turn the control net above the new intersection line from red creases to normans and just leave it there, you might want to raise or lower the keel at a later date.
Mike
Your account
Recent Topics
-
resistance hull data not showing
by
Evergreenboats
2 days, 6 hours ago -
Coordinate system: Transverse reference: definition of “PS” and “SB”
by
rkg
1 week ago -
install problems
by
tcurdt
1 month, 3 weeks ago -
Changing Position of Aft Perpendicular
by
Marcus
2 months ago -
What counts as lateral area?
by
RobinJ
2 months, 1 week ago -
Variables in report headers and footers
by
rkg
2 months, 1 week ago -
Launching curves
by
fridomero@gmail.com
2 months, 3 weeks ago -
Importing AYacht rep files and converting to separate developed plates.
by
Denis Pratt
2 months, 3 weeks ago -
Report capability
by
Tenaja
2 months, 3 weeks ago -
HOW TO IMPORT IMAGES TO DELFTSHIP?
by
TrungQuyet
3 months, 1 week ago