Re:how to connect a sent fin keel to the hull.
› DELFTship forum › Hull modeling › how to connect a sent fin keel to the hull. › Re:how to connect a sent fin keel to the hull.
Connection Keel to Hull,
1 create keel, make it a slightly deeper draft then necessary.
2 move keel to required location with the keel protruding through the hull.
3 go to Edit –> Point –> Intersect layers…. a box will appear, there are 2 lines one above the other, hull in one and keel in the other, cant remember where each one goes (trial and error)
4 An intersection line will appear between the keel and hull. The line should be on the keel surface, it will turn red or make it red, and delete everything above the red intersection line, and there you have it. You can permanently join them to gether but dont as you will change your keel several times during the design cycle.
Mike
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago