Re:how to connect a sent fin keel to the hull.
› DELFTship forum › Hull modeling › how to connect a sent fin keel to the hull. › Re:how to connect a sent fin keel to the hull.
Hi
and thanks for your ideas!
Yes I used the translate/move tools to get close to the hull, but because my hull is not flat at the point I had to moved the fin keel above in order to don t have part of the fin keel not attached to the hull.
I will try to add some points to the hull and see if they can match with the imported part.
I wonder also if i have to move everything to the baseline, or if I have to leave the canoe body at the baseline and the fin keel below;
because I get really different value in the resistance calculation if i move keel and hull above the baseline or not.
Is this normal? does DS recognized negative part of the hull in the resistance calculation, because it does in the hydrostatic…
thanks again
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 4 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months, 1 week ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago