Re:Dimention’s grid does not start from zero anymore
› DELFTship forum › Hull modeling › Dimention’s grid does not start from zero anymore › Re:Dimention’s grid does not start from zero anymore
March 5, 2010 at 07:12
#33997
Participant
It looks like after moving entire model, Zero coordinate (in profile view) starts from intersection of centerline of the hull with DWL. So it is need to move model in opposite (X) direction the same amount as shown on first vertical grid-line.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 1 week ago -
Thank you for helping out!
by
Maarten
2 months, 1 week ago