Re:Delft for Multihull designs?
› DELFTship forum › Hull modeling › Delft for Multihull designs? › Re:Delft for Multihull designs?
October 17, 2009 at 11:42
#33721
Keymaster
Start modelling your outrigger. This can either be symmetrical or asymmetrical.
Then translate it off the centerline and model the middle hull as a conventional hull on the centerplane. Due to the symmetry both the outrigger and the center (half) hull will be mirrored by Delftship to get your complete boat.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 17 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago