Re:bad start
› DELFTship forum › Hull modeling › bad start › Re:bad start
March 10, 2009 at 13:09
#33551
Keymaster
It’s hard to tell since the image is not very clear, but it seems you are using a face which is defined by 6 control points. Usually this introduces a lot of twist in the surface. Try to use only faces of 4 points, or 3 if you don’t have an alternative.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 2 weeks ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago