Re: Twin rudder
› DELFTship forum › Hull modeling › Twin rudder › Re: Twin rudder
July 20, 2011 at 08:24
#35004
Participant
Hi Rob,
I had it already tried directly via the keel and rudder wizard as well as by inserting a part – however, your suggestions got me thinking again and finally I managed it this way:
– hide all other layers (very helpful as you can then use the “select all” function)
– insert a rudder (either directly or as a part, doesn’t matter)
– de-select the check box “symmetrical” in the layer of the rudder
– “mirror” the half rudder still in the center position to get a whole one
– “move” the rudder to the desired position on port side
– repeat procedure for starboard
This may be a bit complicated, but it works – any shortcuts or more elegant solutions welcome!
Best regards,
Bernhard
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago