Re: transome development
› DELFTship forum › Hull modeling › transome development › Re: transome development
April 9, 2011 at 19:28
#34804
Participant
1) … 2) all the developments looked good (number of iterations, edge stretch) except visibly on zooming in the aft edge of the bottom panels were ragged (not a smooth curve edge). The corresponding edges of the port and starboard transome halves were smooth however. What did I do wrong? or is this just a graphics problem where the actual curve exported in dxf code will be smooth?? I am trying to attach the fbm file herewith; hope it comes through. Eric
2. To add new edge to this point, maybe?
Attachments:
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago