Re: transom and deck

[Hrvoje]

Hi, Adriano!

For the deck try this procedure:
* Select boundary edges of the sheer line
* then click “Edit – Edge – Extrude curved”
* in the form which pops up enter needed values
* or just accept default values.
If you don’t like the result click on the “undo” button and try some other values.

Also look at the file “Manual.pdf”, page 31, paragraph 9.5.1 Extrude.

I didn’t use transom so far.
I hope it helped. 🙂

Kind regards, Hrvoje