Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
March 20, 2012 at 19:30
#35716
Participant
At this point I’d recommend just adding a new face where the transom goes to the model rather than try to trim the curved surface down. The hole you’ve created has the same curvature anyway.
It looks nice. Be sure to post it in show me your ships when you’re done.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 35 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago