Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
Thanks again for yr prompt help.
Am always afraid you loose yr patient any time and in that case I would be almost lost!
Anyway it looks like am now on the right “path”, got finally the transom eccess trimmed off and the desired nicely curved transom shape.
Apparently there was a new control point which I extra inserted at the end of the sheer line in order to model a rounded up joint sheer/transom/ deck top line ruther than a corner one. I may have to deal with it later after I got the transom in place!
So now if I put on all 6 control points of curved rurface and go for delete, everything disappears back to the original empity transom area?!
May be I am not doing it correctly?
Do you have any suggestions here too?
Many thanks in advance
Adriano 🙂
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 12 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago