Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
September 14, 2011 at 09:12
#35126

Participant
Hi, Adriano!
There are in your transom some edges you don’t need. Try to get rid of them and than continue to work on waterlines. I attached the picture where you can see suspicious edges.
You have green edges too.
In one of the posts Marven said:
“A green edge indicates you have more than two faces connected to that edge, and in that case the edge is always set to a crease edge, otherwise the mathematics of the surface are ill defined.”
Have a nice day! 🙂
Attachments:
Kind regards, Hrvoje
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 27 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago