Re: transom and deck

[adriano natalini]

Hi Mike,
I tried extruding transom as shown on tutorials but I get just messed up!
Maybe the example is using transom with chined boundary while mine has round boundary?!
Anyhow I am getting to the stage, as shown in the attatchment, where you can see that the centre line of the sofar added racked transom is representing a straight chine which anyhow
should represent the max curve of each waterline in the transom area.
Is there any procedure at this stage to get the water lines curved in the transom
section?
Thanks for any help
Rgds
Adriano

Attachments:

• 4078735018626Transomcentreline.fbm