Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
Have you tried adding a (vertical) cylinder in a separate layer and intersecting this layer with the hull?
Hi Marven,
I did try to model the curved/inclinated transom by “add cylinder” tool.
In this particular case it looks like it’s allmost impossible due to the inclination to get the cylinder perfectly fitting the transom shape!? Indeed despite lots of hand adjusting of both cylinder and transom I cannot get closer than as shown on the attatched file.
At this stage, by intersecting layers, only a distorted transom will come out (obviousely transom edges are adjusted to the adjacent cylinder intersections).
Am I doing anything wrong?
or what would be the alternative to close an inclinated curved transom?
Thanks for any comments 🙂
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 21 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago