Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
February 18, 2012 at 17:23
#35587
Participant
Hi there,
I did created a curved deck as per “extrude curved command” which is very pratical & simple.
Now I need to create a curved transom. I did try at same time of deck extruding but it doesn’t work since the curvature leans towards inside the hull, I need opposite.
I did try to extrude curved separately after the deck by many different trials and ways but it seems to me that it doesn’t work?!
Is there any tool or way which I am not awere of to model a curved transom?
Appreciate any help, thanks
Adriano 🙂
Your account
Recent Topics
-
Revision/save history?
by
Jamie
9 hours, 37 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago