Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
September 13, 2011 at 03:41
#35118
Participant
Theres a tutorial on extruding a transom go to downloads–>tutorials–>reproduding an existing linesplan–>hull modelling tutorial
from experience I extrude the deck and transom in one go to avoid leak points but there is a lot of cleaning up to do so it might not appeal to you.
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 4 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago