Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
February 4, 2012 at 18:00
#35524
Participant
Thanks a lot Marven
I do use that to shape the deck central line which is pretty good and fine but do not think is suitable for what I need now,
most probabily I did not explain quite correctly:
I need to shape the deck curve at each section (deck beams) as well waterlines at the transom,
I thought “create a deck by extruding edges along an arch” tool might be the right one?!
I did try it but no success.
Thanks in advance for further help.
Adriano
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 14 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago