Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
February 3, 2012 at 18:47
#35523
Keymaster
Select your deck edge, and then use the “Extrude curved” command from the edge menu. This will extrude your deck edge along a circular arc
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 17 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago