Re: transom and deck

DELFTship forum Hull modeling transom and deck Re: transom and deck

#35384
AvatarMarven
Keymaster

A possible workaround:

  1. Move the deck to a layer that is not included into the hydrostatics
  2. Extrude the bulwark to a separate layer. Exclude this layer from the hydrostatics
  3. Then modify the “hydrostatics” property from the deck layer so it is included in the hydrostatics calculation

Note: It’s crucial that of each edge (in this case the sheer line) with more than two faces connected a maximum of 2 faces is included for the hydrostatics calculations