Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
November 28, 2011 at 10:52
#35377
Keymaster
Thought the best way was by extruding sheer line but doesn’t work since no longer boundary edge!
Have you tried extruding to a layer that is excluded from the hydrostatics?
If an edge connects more than two faces only two faces are allowed tobe included in the hydrostatics calculations otherwise your calculations will not be valid.
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago