Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
September 20, 2011 at 14:09
#35142
Participant
I had some depression spots on the hull and I used “subdivision controlnet” mode.
Once fixed the problem I wished to go back to normal control net mode.
Apparently once you go on Subdivision control net mode it doesn’t seem possible to go back to the normal “control net” mode without deleting the work done?!
Is anybody aware about this? can anybody give a suggestion?
Thanks
Adriano
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 47 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago