Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
May 31, 2012 at 20:23
#36016
Participant
Hi Dida, Adriano et al,
I made each sail its own layer with ‘Symetric’ unchecked (second check box, to the right of ‘Visible’. The areas I obtained in design Hydrstatics seemed reasonable and with ‘Symetrics’ check they doubled.
I exported the Lines Plan as DXF file and used Turbo Cad to check the areas – they came out the same. I also drew the sail plan up by hand in the old fashioned way and the areas were the same.
The boat is now in build and the sail plan is with my sailmaker. It seems to work for me and I can’t really see anything else to suggest.
What sort of sail configuration are you planning? This current project has a Lugsail and Jib.
All the best
JayOh
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 3 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago